Diferență între revizuiri ale paginii „Counter”

De la WikiLabs
Jump to navigationJump to search
 
Linia 1: Linia 1:
The numerator is a sequential circuit that uses a register to generate a sequence of numbers. The simplest numerator generates a sequence of ascending consecutive numbers. The size of the counter is given by the number of bits of the registers used.
+
The counter is a sequential circuit that uses a register to generate a sequence of numbers. The simplest numerator generates a sequence of ascending consecutive numbers. The size of the counter is given by the number of bits of the registers used.
  
 
The schematic of this device is as follows:
 
The schematic of this device is as follows:

Versiunea curentă din 26 aprilie 2018 07:04

The counter is a sequential circuit that uses a register to generate a sequence of numbers. The simplest numerator generates a sequence of ascending consecutive numbers. The size of the counter is given by the number of bits of the registers used.

The schematic of this device is as follows:

Block schematic of a counter

Note: The count can be used as a frequency divider because each bit has a period twice as high as the previous one, and the bit 0 has a double period over the clock signal:

Value   0   1   2   3   4   5   6   7   8   9 10 11 12 13 14 15 Waveforms
Bit 0 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1 Num0.png
Bit 1 0 0 1 1 0 0 1 1 0 0 1 1 0 0 1 1 Num1.png
Bit 2 0 0 0 0 1 1 1 1 0 0 0 0 1 1 1 1 Num2.png
Bit 3 0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1 Num3.png

Interface of a counter

The interface of a numerator necessarily contains the following ports:

  • Clock signal port;
  • output signal port, which is even the counting register.

In addition, there may still be:

  • Reset port;
  • port that controls the counting direction;
  • port that stops or starts counting;
  • port giving the maximum value the numerator can reach;
  • port that commands to load a start value in the counter of the counter and the port on which this value is given;
  • etc.

Implementing a counter

As a sequential circuit, a counter is implemented exclusively with always sequential blocks.